Sinclair International

I have the privilege to review three products by Sinclair International. The first being a dry fire device for the M16/AR-15 series of rifles. This patented device permits the rifle owner to dry fire without causing damage to the firing pin. The dry fire device slides into the bolt carrier and is invisible when the bolt carrier is in the firearm. The device also allows the trigger to be reset after dry firing. Simply pull the charging handle ¼ of an inch to the rear and you are ready to dry fire again. The device works well for competitive shooters, military personal and law enforcement officers as well as anyone learning an M16/AR-15.

The Dry fire device installs with these three easy steps. 1. Push out the lower take down pin and open the receiver. 2. Insert the dry fire device into the back of the bolt carrier. 3. Cock the hammer, then close the halves and replace the takedown pin. There is no way for the rifle to discharge a round, even if one was cambered.

 

The second item reviewed is a link that goes between the upper and lower receivers of a M16/AR-15 . The purpose of which is to keep the two halves apart while you are cleaning them. The link is made of Delrin and Stainless steel and is impervious to solvents. The link installs in the rear locking pin hole on the upper and the locking pin on the lower. Installation takes only seconds.

 

The third Item is a precision reloading and shooting handbook. This is a guaranteed MUST HAVE for anyone who reloads. In this book, shooters will find techniques to use their tools and equipment, to the fullest extent, including proper preparation for precision reloading and shooting needs. This book contains a good section on bullet coating, barrel break-in and cleaning. There are also quite a few tips for shooting from the bench, which most shooters have to learn from experience. Overall, the book is an easy to read, hands-on guide to reloading and shooting.

 

 

 

www.sinclairintl.com

By: Ken Menge